joncav2222
Moderator

hey man..it say in the manual how to do the dome..take a cloth and a flat head screwdrived and theres alittle slit where you can push it in and itll flap down

the reading lights do the same...on either side, be very careful otherwise youll scratch it..get in there and youll have to wedge it down..it might be hard the first time but IT WILL come down..get one side, and the pull the otherone down and your good

hey man i was just wondering how you removed the dome light and reading lights to switch out the bulbs..i havent rly tried yet but i figured ide ask before i snap anything lol

check out the 8-8-09 meet... any interest in coming out?

if your talkin about the footwell leds? then what i did whas sliced with an exacto knife alittle bit of the carpter of the underseat..and zip tied it from that little slice around the tube and back into the hole..

you would want to cut on the actual seat it saelf and not the carpet of the floor..theres alil section underneath that would hid them perfectly from being seen..dont be afraid to cut cause noone would ever notice..you would thm to end up the same way the front ones are,,

its very simple for the rear an only took maybe 15 minutes to do after running all the wires..

yo, you had/have interior led's right? like the 15/18 bulb tubes, i saw you had a video of it. anyways. where did u put the back ones? i put the front ones hidden by the feet... but the back ones dont really go well anywhere... ?